Nissan 350Z LHD Gas Pedal Assembly with premium metal pedal.
Fitment:
Nissan 350Z
Nissan S13 LHD (Minor modification required)
NOTE: Nissan Pedals may be substituted for replacement parts dependi...
Most 90s to early 2000s Nissan gas pedal assemblies come with a black plastic pedal cover. Upgrade to a OEM Nissan 350z alloy sport pedal cover.
Fits:
Nissan 350Z
Nissan S/R/Z chassis from 90s t...
It's recommended that these valve cover gaskets get checked and replaced if necessary. When they get old, the have a tendency to release their seal and cause oil leaks that can sometimes leak down ...
Use left/right arrows to navigate the slideshow or swipe left/right if using a mobile device
Choosing a selection results in a full page refresh.
Press the space key then arrow keys to make a selection.
Shopping Cart
Koty L
Speed sensor plug
Excellent fit fast shipping thanks !
Transmission Speed Sensor Plug for RB25 & RB26
IG : hawaiian_boi86_is300
Great product (1JZ GTE VVTI swapped IS300)
Great product, overall satisfied. Customer service is top tier and the end result is a great looking and easy to install throttle body. Thank you outsider garage. I highly recommend this setup.
Toyota Supra Complete DBW Conversion Kits
Raheel
Great quality
This quality of the injector harness cover is top notch. I did add the DEI gold film inside to possibly help with the heat.
Couldn't fit any better with the Mishimoto radiator on my vr4.
Mitsubishi 3000GT Top Radiator Mounts
Sleeper Tuning
Best bang for you buck intake
I have been selling and installing these intakes for years. We have tested these intakes to an extreme level of performance using them on our personal drag car with 60psi of boost an nitrous on top with zero failures. We have run low 7 second passes at over 180mph in a 3400lb car and never missed a beat. Its not any new news that they are made in china and come from a similar factory as the other china billet intake but zero fab puts in the extra time for quality control by making sure the welds are penetrated properly, the power are lined up and match and the flanges are matched flat. Nobody else does this. Ive seen the "same" intake from another brand and u can see the difference in the finish product.
